Flash Loader Ip Not Loaded On Device 1 File

// Disable low-power modes during debug __HAL_DBGMCU_DISABLE_SLEEP(); __HAL_DBGMCU_DISABLE_STOP(); __HAL_DBGMCU_DISABLE_STANDBY(); Then, erase the faulty firmware that put the chip to sleep.

ST-Link_CLI -c SWD UR -ME (Where -c SWD UR = Connect SWD Under Reset, -ME = Mass Erase) Then try programming again. Flash Loader Ip Not Loaded On Device 1

Few things are more frustrating in embedded development than a successful connection to your microcontroller, only to be met with the cryptic error: you can see the target voltage

You can read the device ID, you can see the target voltage, but the moment you try to erase or flash firmware, the programmer halts with this message. This post explains why this happens and provides a step-by-step guide to resolve it. Flash Loader Ip Not Loaded On Device 1