Gy-85 Datasheet Pdf -

void setup() Wire.begin(); // Initialize ITG-3200 (write 0x3E to register 0x3E for PLL) Wire.beginTransmission(ITG3200_ADDR); Wire.write(0x3E); Wire.write(0x00); // Sample rate divider Wire.endTransmission();

// Initialize ADXL345 (set power control) Wire.beginTransmission(ADXL345_ADDR); Wire.write(0x2D); // Power control register Wire.write(0x08); // Measure mode Wire.endTransmission();

#include <Wire.h> // I2C addresses from datasheets #define ITG3200_ADDR 0x68 #define ADXL345_ADDR 0x53 #define HMC5883L_ADDR 0x1E

The GY-85 is a popular, low-cost Inertial Measurement Unit (IMU) breakout board. It is widely used in Arduino and Raspberry Pi projects for motion sensing, orientation tracking, and stabilization. However, unlike newer modules (such as the MPU-6050 or MPU-9250), the GY-85 does not use a single integrated chip. Instead, it combines three separate sensors from InvenSense and Hitachi.