New- Hints And Kinks For The Radio Amateur -

Use a second mat as a soldering iron rest when traveling. The iron tip won’t burn it, and it won’t slide off the table. A Final Word The best kink is the one you discover yourself. Keep a small notebook in your shack (or a digital note) and write down every “that worked well” or “that was stupid, don’t do it again.”

Loosen the element set screw. Slide the element until it touches the clamp. Tighten. Check SWR. Move clamp up or down by measured inches. No more lowering the mast 15 times. 6. Cleaning Potentiometers Without Deoxit (Field Hack) The problem: Scratchy volume or tone control on your vintage receiver, and you’re out of contact cleaner.

73, and may your SWR be low and your soldering iron hot. Do you have a kink to share? Send it to your club newsletter or post it on QRZ—that’s how our tradition stays alive. New- Hints and Kinks for the Radio Amateur

Tried-and-true tricks, fresh twists, and shop-tested solutions for the modern shack

Not always, but in a pinch, stranded 18-gauge wire soaked in flux outperforms no wick at all. Keep a 6" piece pre-fluxed in a tiny ziplock bag in your go-kit. 3. The "Eyeglass" SMA Wrench (Free & Perfect) The problem: SMA connectors need to be finger tight plus 1/8 turn . Overtighten, and you’ll snap the center pin or ruin the female receptacle (especially on cheap HTs or SDR dongles). Use a second mat as a soldering iron rest when traveling

Remove the knob. Drip 2–3 drops of isopropyl alcohol (91% or higher) into the shaft opening. Rotate the pot back and forth fully 20–30 times. Let it dry 5 minutes. Then add one tiny drop of lightweight machine oil (sewing machine oil or even 3-in-1) to the same spot. Rotate again 10 times.

By WB2FAS (In the spirit of the original QST column) Keep a small notebook in your shack (or

Let’s face it: half the fun of amateur radio is the tinkering. We love solving the little problems—the RF in the shack, the cable mess behind the desk, the soldering iron that’s never hot when you need it. Here’s a fresh batch of hints and kinks to save you time, money, and frustration. The problem: You slip a ferrite bead over a coax cable, but it rattles around and slides right off the bend. Not effective.